** In this video you get to see a basic configuration that I did to create pulses of DC power. I am using two double A batteries to power a small electric motor. This shaft is glued to the frame I pulled out an identical engine, electric motors and brushes and end piece can also be seen. The red pancake coil is connected to my 12 volt, 2 amps of current. Now, the interesting thing about this setup is that I use more armor per pulse of 12 volts DC. I accomplished this by two of the three segments of copper welding armor together. This leaves one disconnected segment, and then, when it rotates, it cuts the power on and off about 13 times per second. This is a very crude way to DC pulse, but it works. The small neodymium magnet in the shape of the sphere vibrates very fast and loud when placed next to the pancake coil, when in operation. It ‘also sucked into the eye of the coil …. or rather, the eye of the magnetic vortex created by the coil. It ‘been said in the literature that Nikola Tesla experimented with a lot of Pulsed DC. What might be called energy boost. Tesla learned that when high-voltage electrical pulse is fast enough, you can split apart the underlying etheric component units of electricity in the first place. One can reason that the flow of electrons in an underlying stream of etheric substance, which is the true power and force behind the flow of electrons. Tesla found that pulsed DC when connected to the coils special …
Video Rating: 4 / 5